摘要:介紹了高吸濕纖維的國內外研究現狀及高吸濕纖維的分類方法;以上海正家纖維公司出產的淼卡纖維為試樣,測定了在溫度為22℃、相對濕度為64%的條件下,該纖維的部分物理性質,包括平均回潮率為31.96%,平均細度為2.19 dtex,纖維的平均拉伸強力為3.36cN;測試了淼卡纖維在標準大氣條件下的吸放濕性能,給出了纖維在標準大氣條件下的吸放濕曲線,并對實驗結果進行分析,得出結論:淼卡纖維具有很強的吸濕能力,屬于快吸慢放型纖維,且纖維存在較大的吸濕滯后性,得到纖維的吸濕滯后值為18.98%。
關鍵詞:高吸濕纖維、吸濕、放濕、纖維性能
Abstract:This article shows the research status and classifications of fibers with high moisture absorption. In the experimental part, the Miaoka fiber, which is produced by Shanghai Zhengjia Fiber Company, has been taken for testing sample with some of the physical properties have been tested, obtained that the average moisture regain of the fibers is 31.96%, the average fineness of the fibers is 2.19 dtex, the average tensile strength for the fiber is 3.36cN,at conditions that temperature is 22 ℃, 64% relative humidity conditions. The moisture absorption and desorption of Miaoka fiber have been tested under the standard atmospheric pressure, so the curve of the moisture absorption and desorption of Miaoka fiber has been given. The experiment result has been analyzed and get the conclusion that Miaoka fiber has a strong moisture absorption ability, it belongs to quick absorption and slow desorption fiber and it has big hysteresis quality, the percentage of hysteresis quality is 18.98%
Keywords: high hygroscopic fiber; moisture absorption; moisture desorption
近年來,隨著人們生活水平的提高,對于服裝或服裝面料舒適性的要求越來越高,而服裝穿著的舒適性與材料的吸放濕特性密切相關[1-2]。因此,國內外對于吸水、吸汗纖維的研究與開發愈來愈重視,該類纖維的生產規模迅速的擴大[3]。
目前,高吸水纖維的主要生產國有加拿大、美國、日本等,其中屬日本在這方面的研究經驗及產品開發最為豐富。加拿大阿爾伯達省卡爾加利市的Camelot Super absorbents有限公司在1994年便開始高吸水纖維Fibirdri和Fiberborb的中試生產[4];美國Arco化學技術公司、Bix Fiberfilm公司和Asahi化學公司在高吸濕纖維的生產研究領域也占有很大分量。而日本在這方面的研究相當廣泛:比如鐘紡是日本最大的高吸水纖維生產廠家,2002年高吸水纖維產量達到3500噸/年,其產品是聚丙烯酸鹽高吸水纖維及高吸水無紡布[5];日本東麗公司在尼龍6中混入特殊的高吸濕性聚合物而制得的均勻相溶的聚合物混合體Quup,Quup既保持了尼龍原來的特性,又能使吸濕性提高2倍[6]。
1 高吸濕纖維的分類
1.1原料分類
(1) 纖維素類:通過對纖維素進行化學改性,將強親水性的羧基引入纖維素的大分子鏈,進行羧甲基化。
(2) 聚羧酸類:以聚羧酸和羧酸的共聚物為主要原料,添加其它可紡性較好的聚合物紡絲制備高吸水纖維。所制備的高吸水纖維可熱交聯,也可加入適量的多元醇交聯,常用的不飽和羧酸單體主要有丙烯酸、甲基丙烯酸、丁烯酸等。
(3) 聚丙烯腈類:通過對腈綸纖維的外層進行選擇性親水改性,改性后的外層和未發生變化的內層共同構成皮芯結構高吸水纖維。
(4) 改性聚乙烯醇類:聚乙烯醇是一種有大量親水基團的聚合物,它具有水溶性,能吸收大量的水分,如果向聚乙烯醇分子內引入羧基后,效果更顯著[7]。
相關信息 







推薦企業
推薦企業
推薦企業